System Start-Up; Filling The Water Heater; Initial Setup - Atlantic Explorer Installations- Und Bedienungsanleitung

Presentation

10. System start-up

10.1. Filling the water heater

❶ Open the hot water tap(s).
❷ Open the cold water tap on the safety unit (ensure that the safety unit drain valve is closed).
❸ Close the hot water valves after draining them. The water heater has been filled with water.
❹ Check the sealing of the pipe socket connections.
❺ Check the operation of the hydraulic components, by repeatedly opening the safety unit drain valve
to eliminate any residue in the discharge valve.
10.2. Initial set-up
If the water heater has been tilted, wait at least 1 hour before powering on.
Decrease / Navigate
❶ Power on the water heater.
❷ When you do so for the first time, the setting instructions will be displayed.
Follow these instructions carefully to apply the settings
- Language selection
- Date and time setting
- Installation type:
-> Ventilation
-> Coil connection
-> Recirculation loop
- External control
- Heating times (Time programming)
- Electric heating element
- Setpoint management
To return to the settings at a later date, or for more information on commissioning, refer to the "Installation
parameters" paragraph.
For the first heating, activate the BOOST to heat the water quickly.
Installation
Confirm
Back
Use Maintenance
Information display
Instructions
Increase / Navigate
Menu
Warranty