Bosch VBD5780S0 Gebrauchs- Und Montageanleitung Seite 41

Never operate the appliance if the seal is damaged or
missing.
Remove the shelf supports and pull-out rails from the
1.
cooking compartment.
Remove coarse dirt from the cooking compartment.
2.
Clean the inside of the appliance door and along the
3.
edges of the cooking compartment in the area
around the seal. Do not scrub the seal.
Setting the cleaning function
Ventilate the kitchen while the cleaning function is run-
ning.
WARNING ‒ Risk of harm to health!
The cleaning function heats up the cooking compart-
ment to a very high temperature so that food left over
from roasting, grilling and baking will burn off. This pro-
cess releases vapours, which can irritate mucous mem-
branes.
Keep the kitchen well ventilated while the cleaning
function is running.
Do not remain in the room for long periods.
Keep children and pets away.
WARNING ‒ Risk of burns!
The cooking compartment gets very hot when the clean-
ing function is in progress.
Never open the appliance door.
Allow the appliance to cool down.
Keep children at a safe distance.
The outside of the appliance gets very hot when the
cleaning function is in progress.
Never touch the appliance door.
Allow the appliance to cool down.
Keep children at a safe distance.
Use the function selector to set
1.
Use and to select the pyrolytic self-clean func-
2.
tion .
Use the temperature selector to set a cleaning level.
3.
Cleaning level
1
13 Rails
Rails
To thoroughly clean the rails and the cooking compart-
ment, or to replace the rails, you can remove the rails.
13.1 Detaching the rails
The rails are each fixed to the side panels of the cook-
ing compartment at 3 points.
Grip the front of the rail and pull it round to the
1.
middle of the cooking compartment.
The front hook of the rail comes out of the hole.
.
Duration in h
2:30
Cleaning level
2
3
One minute after the cleaning cycle for the pyrolytic
self-cleaning begins, the appliance door is locked to
prevent it from being opened. The indicator light
shows the activation of this door opening mechan-
ism. Once the door lock has been activated, you can
no longer select any functions. Wait until the indic-
ator light goes out.
Notes
If you do not want to end the pyrolytic self-cleaning
early, do not change the function selector during the
cleaning cycle.
You will not be able to use the interior lighting while
the pyrolytic self-cleaning programme is in progress.
Tip: You cannot use the timer while the pyrolytic self-
cleaning programme is in progress. The duration has no
effect on the pyrolytic self-cleaning function.
Cancelling the cleaning function
Turn the function selector to the off position.
Preparing the appliance for operation after the
cleaning function
Requirements
Once the self-cleaning function has run through to the
end, a signal tone sounds.
If goes out on the display, you can open the appli-
ance door.
Allow the appliance to cool down.
1.
Wipe off any ash that has been left behind in the
2.
cooking compartment, on the shelf supports and
around the appliance door with a damp cloth.
Note: White residues on the enamel surfaces may be
caused by heavy soiling. These food residues are harm-
less. The deposits do not compromise the functionality
of the appliance. You can remove these residues using
lemon juice if required.
Swing the rail round further and pull it out of the rear
2.
holes in the side panel.
Remove the rail from the cooking compartment.
3.
Rails en
Duration in h
3
3:30
41