AERMEC MODUCONTROL Bedienungsanleitung Seite 64

MODUCONTROL
25/01 6343841_06
14 INSTALLER 3 MENU
To access the installer 3 menu, follow the same procedure described for the installer menu; the only difference is the value
of the password, which is 84.

PASSWORD = 084
Fig. 9b
Fig. 10b
The following parameters must only be modified by qualified personnel authorised to install the unit.
14.1 SETTING OPERATIONAL PARAMETERS (INSTALLER LEVEL)
Index - String MIN value MAX value
0, 1 , 2, 3 0
Index - String MIN value MAX value
2.0V
4
64
NOTICE
Factory commissioning
999 Factory commissioning
Setting maximum DCP Volt
This parameter allows you to set the maximum speed of the fans in the CL units, the
greater the value of this parameter, the higher the pressure available at fan; for an
9.9V
accurate setting of this parameter, please consult the table "Setting maximum DCP
Volt "the manual installation of the units CL.
Parameter function
Parameter function