Scheppach HS550 Originalbetriebsanleitung Seite 26

• All protective and safety equipment must be reas-
sembled immediately after repair or when mainte-
nance is completed.
• The safety, operating and maintenance information of
the manufacturer, as well as the dimensions specified
in the technical data, must be observed.
• The relevant accident prevention regulations and
the other generally accepted safety rules must be
observed.
• Make sure that you have secure footing and always
maintain your balance.
• Check the power tool for potential damage!
• Protective devices or other parts with minor damage
must be carefully inspected to ensure that they func-
tion correctly and as intended prior to continued use
of the tool.
• Check whether the moving parts function faultlessly
and do not jam or whether parts are damaged. All
parts must be correctly mounted and all conditions
must be fulfilled to ensure fault-free operation of the
tool.
• Damaged protective devices and parts must be re-
paired properly or replaced by a recognised special-
ist workshop unless otherwise specified in the usage
instructions.
• This tool conforms to the applicable safety regulations.
Repairs may only be performed by a specialist using
original spare parts. Otherwise accidents could occur.
• If necessary, wear suitable personal protective equip-
ment. This could include:
- Hearing protection to prevent the risk of develop-
ing hearing loss;
- Respiratory protection to avoid the risk of inhaling
damaging dust.
• Wear gloves when handling saw blades and rough
materials. Saw blades must be carried in a container
whenever practical.
• Wear personal protective equipment and always
safety goggles.
• The operator must be informed about the conditions
that affect the noise levels (e.g. saw blades designed
to reduce noise, care of saw blade and machine).
• Faults in the machine, including the guards and the
saw blade, must be reported to the person responsi-
ble for safety as soon as they are discovered.
• When transporting the machine, use only the trans-
port devices and never use the guards for handling
and transport.
• All operators must be adequately trained in the use,
setting and operation of the machine.
• Do not saw any material to be cut that contain foreign
bodies such as wires, cables or cords.
• Only use sharp saw blades.
• The machine must be on a horizontal, level floor dur-
ing operation and the floor around the machine must
be level, well maintained and free of waste such as
chips and cut-off workpieces.
Warning!
This power tool generates an electromagnetic field dur-
ing operation. This field can impair active or passive
medical implants under certain circumstances. In order
to prevent the risk of serious or deadly injuries, we rec-
ommend that persons with medical implants consult with
their physician and the manufacturer of the medical im-
plant prior to operating the power tool.
www.scheppach.com GB | 26