Scheppach HS550 Originalbetriebsanleitung Seite 23

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability for
damage to the product or caused by the product arising
from:
• Improper handling
• Failure to comply with the operating instructions
• Repairs carried out by third parties, unauthorised spe-
cialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100,
DIN 57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating instructions before
assembly and commissioning.
This operating manual should help you to familiarise
yourself with your product and to use it for its intended
purpose.
The operating manual includes important instructions
for the safe, proper and economic operation of the prod-
uct, for avoiding danger, for minimising repair costs and
downtimes and for increasing the reliability and extend-
ing the service life of the product.
In addition to the safety instructions in this operating
manual, you must also observe the regulations applica-
ble to the operation of the product in your country.
Keep the operating manual with the product at all times
and store it in a plastic cover to protect it from dirt and
moisture. They must be read and carefully observed by
all operating personnel before starting the work.
The product may only be used by personnel who have
been trained to use it and who have been instructed with
respect to the associated hazards.
The required minimum age must be observed.
23 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country, the
generally recognised technical rules relating to the oper-
ation of such machines must also be observed.
We accept no liability for accidents or damage that occur
due to a failure to observe this manual and the safety
instructions.
2. Product description (Fig. 1 - 11)
1. Protective cover
2. Handle
3. Feed rocker
3a. Swivel frame extension
3b. Collar nut M6
3c. Carriage bolt M6
4. Mains plug 230 V / 400 V
5. On/off switch
6. Engine
6a. Saw blade
6b. Inner saw blade flange
6c. Outer saw blade flange
6d. Washer
6e. M12 x 30 mm bolt
7. Protective flap
7a. M8 x 35 mm bolt
7b. M8 x 35 mm bolt
7c. Wing screw
8. Safety split pin (saw blade)
8a. Opening for the locking device (saw blade)
9. Swivel frame lock
10. Wheel
10a. 20 mm washer
10b. Split pin
10c. Wheel axle
11. Connection port (extraction) *
11a. M5 wing screw
11b. 5 mm washers
12. Guide plate (outer)
12a. Spring split pin
13. Ring spanner, size 13/18
www.scheppach.com