Faber KOLDING Installationsvorschrift Seite 66

EN
PROBLEM
Hearth will not tight or goes
out.
The flame is poorly
distributed.
EN 20
9. DISRUPTIONS
CAUSE
- Air in supply pipe (after
appliance has been out of
operation).
- Insufficient gas pressure.
- The pilot light is dirty.
- The thermocouple contact
does not engage properly.
- The oxypilot feature is
activated.
- The wood blocks are not
positioned properly.
The burner is quite dirty
because of ash from
combustible materials has
gotten into the burner.
SOLUTION
- Vent.
- Check that the gas tap is
open and check the gas
line to see if it is dirty.
- Clean the burner carefully
with a vacuum cleaner.
- Check the thermocouple
circuit.
- The oxypilot activates if
there is too little oxygen in
the air. Ensure that there
enough fresh air.
- Arrange the wood set
properly.
- Clean the burner carefully
with a vacuum cleaner.
careful not to damage the
burner with the sharp
edges of the vacuum
cleaner.
is
Be