Scheppach BG150 Originalbetriebsanleitung Seite 32

• In the case of delivery of a new electrical device by
the manufacturer to a private household, the latter
may arrange for the free collection of the old elec-
trical device upon request from the end-user. Get in
contact with the manufacturer's customer service.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. Different provisions may apply to the
disposal of electrical and electronic appliances in
countries outside the European Union.
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Problem
Engine does not run.
The engine starts slowly
and does not reach the
operating speed.
Engine producing
excessive noise.
Engine does not reach
full power.
Motor overheats easily.
32 | GB
Possible causes
Engine, cable or connector
defective, fuses burnt.
Voltage too low, coils
damaged, capacitor burnt.
Coils damaged, motor
defective.
Circuits in the network are
overloaded (lamps, other
motors, etc.).
Overloading of the engine,
insufficient cooling of the
engine.
www.scheppach.com
Remedies
Have the machine checked by a specialist. Never
repair the engine yourself. Attention! Check the
fuses and replace them if necessary.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Have the engine checked by a specialist.
Do not use any other devices or engines on the
same circuit.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum
engine cooling.