Scheppach BG150 Originalbetriebsanleitung Seite 28

m WARNING
Excessive and frequent exposure to noise can lead to
hearing damage or hearing loss.
- Wear hearing protection
- Take breaks.
Total vibration values (vector sum of three directions)
determined according to EN 62841.
NOTE: The specified device emissions values have
been measured in accordance with a standardised test
procedure and can be used for comparison of one elec-
tric tool with another.
The specified device emissions values can also be
used for an initial estimation of the load.
WARNING: The noise emission values can vary from
the specified values during the actual use of the power
tool, depending on the type and the manner in which
the electric tool is used, and in particular the type of
workpiece being processed.
Implement measures to protect against noise nuisance.
In doing so, take into account the complete working
process, including the times when the power tool is
working without load or switched off.
Suitable measures include regular maintenance and
care of the power tool and the insertion tools, regular
breaks as well as proper planning of the working pro-
cess.
It is necessary to define safety measures to protect the
operator which are based on an estimate of vibration
exposure during the actual operating conditions (for
this, all parts of the operating cycle have to be consid-
ered, e.g. times during which the power tool is switched
off and times during which it is switched on but runs in
no-load mode).
8. Unpacking
m DANGER
Danger of choking or suffocating
The packaging material, packaging and transport safe-
ty devices are not children's toys. Plastic bags, foils
and small parts can be swallowed and lead to choking.
- Keep packaging material, packaging and transport
safety devices away from children.
28 | GB
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, packaging and
transport safety devices (if applicable).
• Check the completeness of the scope of delivery.
The customer service must be notified immediately
of any complaints. Later claims will not be recog-
nised.
• Check the scope of delivery for transport damage.
The transport company must be notified immediate-
ly of any complaints. Later claims will not be recog-
nised.
• Keep the packaging until the end of the warranty
period.
• Read through the operating manual completely.
• Only use original spare parts or accessories. Origi-
nal spare parts or accessories can be obtained from
your specialist dealer.
• Check that the data on the type plate matches with
the mains power data.
9. Assembly
Before connecting the machine, make certain that the
data on the type plate matches with the mains pow-
er data.
Always pull out the mains plug before carrying out
adjustments on the device.
Safety instruction! Do not connect the device until all
assembly and adjustment work has been completed
and the operating manual and safety instructions have
been read and understood.
m Attention!
Always make sure the device is fully assembled
before commissioning!
• Prior to commissioning, all covers and safety devic-
es must be mounted correctly.
• The grinding disc must be able to run freely.
• Before connecting the machine, make certain that
the data on the type plate matches with the mains
power data.
9.1 Fitting the bench grinder onto the workbench
(Fig. 1)
The machine must be stable, i.e. bolted down on a
workbench or similar. be screwed tight.
1. Set the bench grinder on a stable, even and level
workbench.
www.scheppach.com