Haier AW042MUGHA Installationsanleitung Seite 25

Installation Instruction
(1) Installation place selection
The unit can't be installed in the
place with inflammable gas. Or
it will cause fire hazard.
The unit should be installed at
the place where the cold/hot
air or noise will not interfere the
neighbours.
The unit shall not be installed
above windows or doors.
Important:To install the Heat pumps safely,carry out the Installation Risk Analysis with reference to EN 378 part 3.
The unit should be installed at the
place with good ventilation. No
obstacle at the air inlet/outlet. And no
strong wind blows the unit.
The installation space refers to the
latter info.
• The place where the water can flow
fluently.
• The place where no other heat
source will affect the unit.
• Pay attention to the snow against
clogging the outdoor.
• In installation, install the anti-
vibration rubber between the unit
and the bracket.
The unit shall not be installed near
basement windows, skylights,
ventilation system opening, and areas
around the bottom of stairs going to
the basement.
18
The unit should be installed at the strong
enough place. Or it will cause vibration and
noise.
• The unit can't be installed in the
basement or at the below places.
• The place where there is corrosive gas
(spa area etc).
• The place blowing salty air (seaside etc).
• Exsits the strong coal smoke.
• The place with high humidity.
• The place where there is device emitting
Hertzian waves.
• The place where voltage changes greatly.
Do not install the unit near electrical systems,
outlets, lighting fixtures, or light switches.