Specification - Aim-TTI LDH400P Bedienungsanleitung

1. Specification

Accuracy specifications apply for 18°C – 28ºC, using the rear panel terminals, after 30 minutes
operation at the set conditions. Setting accuracies apply with slew rate at the 'Default' setting.
INPUT
Maximum Input Ratings
Current:
Voltage:
Power:
Minimum Operating Voltage: 10V.
Minimum effective
resistance:
Off State Leakage:
Reverse Polarity:
Isolation Voltage:
Input Terminals
Rear Panel Input:
Front Panel Input:
OPERATING MODES
Constant Current Mode (CC)
Current Range:
Setting Accuracy:
Regulation:
Temperature Coefficient:
(1)
Slew Rate Range:
(2)
Minimum transition time:
Constant Power Mode (CP)
Power Range:
Setting Accuracy:
Regulation:
Temperature Coefficient:
(1)
Slew Rate Range:
(2)
Minimum transition time:
16 Amps max. through the front and rear panel terminals.
500 Volts max. while conducting current.
400 Watts max. up to 28ºC, derating to 360 watts at 40ºC.
1Ω .
<5 mA (including voltage sense circuit input resistance - typically
1180kΩ to load negative).
Body diode will conduct; 16 Amps max.
CAT II (300V) either load input to chassis ground.
Safety terminals accepting 4mm plugs at 16 Amps max.
Safety terminals accepting 4mm plugs at 16 Amps max.
0 to 16 A (1 mA resolution).
± 0·2% ± 30 mA.
< 30 mA for 90% load power change (V > 25 Volts).
< (±0·02% ± 5 mA) per ºC.
5 Amp per s to 500 Amp per ms.
50 µs.
0 to 400 Watts (100 mW resolution).
± 0·5% ± 2 W ± 30 mA (V > 25 Volts).
< 2% over 25 V to 550 V source voltage change.
< (± 0·1% ± 5 mA) per ºC.
60 W per s to 6000 W per ms.
150 µs.
3