Specification - Aim-TTI PL-P SERIES Bedienungsanleitung

MAIN OUTPUT(S) - LOCAL OPERATION
Output Range:
Output Voltage Setting:
Output Current Setting:
Output Mode:
Output Switch:
Output Terminals:
Sensing:
Output Impedance:
Constant Voltage:
Constant Current:
Output Protection:
Load & Line Regulation:
Ripple and Noise:
Transient Response:
Temperature Coefficient:
Meter Type:
Meter Resolution:
Meter Accuracy:
Current Meter Damping:
MAIN OUTPUT(S) - REMOTE OPERATION
All specifications identical to LOCAL operation, with the following additions/exceptions:
Output Voltage Setting:
Output Current Setting:
Setting Accuracy:
Output Switch:
Readback Resolution:
Readback Accuracy:
Current Meter Damping:
LOGIC OUTPUT - LOCAL OPERATION
Output Voltage Range:
Output Current:
Output Switch:
2
0-32V Volts nominal
0-3·1A nominal
By coarse and fine controls; resolution <5mV across the range.
By single logarithmic control.
Constant voltage or constant current modes with automatic cross-over.
Decimal points flash to indicate constant current mode.
Isolates the output and permits voltage and current limits to be set up
before connecting the load.
4mm terminals on 19mm 0·75") spacing.
Remote via 4mm terminals or direct via shorting links (provided).
<5 mΩ at 1kHz.
Typically 50 kΩ with voltage limit at maximum.
Up to maximum output voltage +20 Volts forward; diode clamped for
reverse voltages and up to 3A reverse current.
< 0·01% of maximum output for 90% load change or 10% line change.
Typically <1 mV rms.
< 20 µsec to within 50 mV of setting for 90% load change.
O
Typically < 100 ppm/
Dual 3·75 digit (4095 count) with 12·5mm (0·5") LEDs. Reading rate 4Hz.
10 mV and 1mA over the entire range.
Voltage 0·1% of reading + 1 digit, current 0·3% of reading + 1 digit.
~20 ms, switchable to 2 sec for averaging of rapidly varying loads.
12 bit resolution (10 mV steps).
12 bit resolution (1mA steps).
Voltage 0·1% ± 10mV, current 0·2% ± 2mA
Electronic by interface command (front panel switches must be ON).
10mV and 1mA over the entire range.
Voltage 0·1% of reading + 1 digit, current 0·3%% of reading + 1 digit.
~ 20 ms switchable to 2 sec and back by remote commands.
4 to 6 Volts.
0·1 to 7 Amps.
Electronic.

Specification

C.