RK Rose+Krieger RK MonoLine R Montageanleitung Seite 99

Positioning clamping bars
Fig. 15: Positioning clamping bars
Fixing clamping bars
Fig. 16: Fixing clamping bars
A Distance between fixing holes
B Required space
5.3.2 Assembling a linear unit with slot stones
Applicable to
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
27.10.2023
Assembling the linear unit on the substrate > Assembling a linear unit with slot stones
2. Ensure that a distance of 300 mm between the clamping bars
(Fig. 15/1) is not exceeded at maximum load.
3. Tighten two screws (Fig. 16/1) for each clamping bar
(Fig. 16/2).
For this, observe the following:
Size A [mm] B [mm] Screw size Tightening
40 52
60 80
80 100
120 140
ð The linear unit is installed on the substrate.
Version RK MonoLine R, Z, Z
Size 40/60/80/120
65 M6
100 M8
120 M8
160 M8
Assembly
torque [Nm]
10
25
25
25
99