RK Rose+Krieger RK MonoLine R Montageanleitung Seite 109

5.4.4 Assembling the limit switch
5.4.4.1 Assembling the mechanical limit switch
Applicable to
Assembling the actuator
Fig. 35: Assembling the actuator
Assembling the limit switch
Fig. 36: Assembling the limit switch
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
27.10.2023
Assembling optional modules > Assembling the limit switch
Version RK MonoLine R, Z
Size 40
Personnel:
Protective equipment:
Prerequisite:
n The electric gear unit and/or motor (if available) are secured
against restarting.
1. Insert and position the slot stones (Fig. 35/1) in the slot of the
guide carriage.
2. Place the actuator (Fig. 35/2) at the height of the inserted slot
stones.
3. Tighten 2 screws (Fig. 35/3):
Size Screw size
40 M4
4. Insert and position the slot stones (Fig. 36/1) in the slot of the
guide profile.
5. Place the limit switch (Fig. 36/4) along with a mounting
bracket (Fig. 36/3) at the height of the inserted slot stones.
6. Tighten 2 screws (Fig. 36/2):
Size Screw size
40 M4
ð The limit switch is assembled.
n Assembly staff
n Protective clothing
Protective gloves
n
n Safety shoes
Tightening torque [Nm]
2
Tightening torque [Nm]
2.1
Assembly
109