RK Rose+Krieger RK MonoLine R Montageanleitung Seite 108

Assembly
Assembling optional modules > Assembling the drive shaft
Assembling the drive shaft
Fig. 33: Assembling the drive shaft
Applicable to
Assembling the drive shaft
Fig. 34: Assembling the drive shaft
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
108
3. Place the drive shaft (Fig. 33/2) on the adapter washer
(Fig. 33/1).
4. Tighten 4 screws (Fig. 33/3) alternating diagonally:
Size Screw size
40 M4
80, 120 M6
The drive shaft for the RK MonoLine Z 80
and 120 are connected to the adapter
washer with 8 screws each.
ð The drive shaft is assembled.
Version RK MonoLine Z, Z
Size Z 60, Z 80
Personnel:
Protective equipment:
Prerequisite:
n The electric gear unit and/or motor (if available) are secured
against restarting.
1. Place the drive shaft (Fig. 34/2) on the timing belt shaft
(Fig. 34/1).
2. Tighten 4 screws (Fig. 34/3) alternating diagonally:
Size Screw size
Z 60 M8
Z 80 M8
ð The drive shaft is assembled.
Tightening torque [Nm]
3
15
Assembly staff
n
n Protective clothing
n Protective gloves
n Safety shoes
Tightening torque [Nm]
25
35
27.10.2023