RK Rose+Krieger RK MonoLine R Montageanleitung Seite 83

Falling components
Worn timing belt
2.3.3 Thermal hazards
Hot surfaces
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
27.10.2023
CAUTION!
Risk of crushing and impact due to the guide
carriage falling!
If linear units are aligned at an incline or vertically,
the guide carriage can fall down on its own and
cause injuries.
– Secure the guide carriage against falling down
on its own, e.g. by using a holding module or a
linear brake.
– Slide the guide carriage into the bottom end
position.
CAUTION!
Risk of cutting on the worn timing belt!
Wear can cause stranded wires to protrude from
the timing belt, which may lead to cuts.
– Check the timing belt regularly for wear.
Observe the maintenance intervals.
– Proceed with care when carrying out work on a
worn timing belt.
– Do not let the timing belt run through your fin-
gers. Wear protective gloves if necessary.
Depending on whether an optional gear unit and/or a motor is
used, the following applies:
WARNING!
Risk of injury due to hot surfaces!
The surface of the pulley box can heat up signifi-
cantly due to the heat transfer of a mounted gear
unit and/or motor in operation.
Skin contact with hot surfaces can lead to severe
burns.
– Wear heat-resistant protective clothing and
protective gloves when carrying out any work
in the vicinity of hot surfaces.
– Before starting any work, ensure that all sur-
faces have cooled down to the ambient tem-
perature.
Residual risks > Thermal hazards
Safety
83