RK Rose+Krieger RK MonoLine R Montageanleitung Seite 124

Technical data
Load data > No-load torques, pitch circumference and pitch diameter of the pulley
9.2 Load data
Safety factors
Exceeding the load data
Movable total mass
9.2.1 No-load torques, pitch circumference and pitch diameter of the pulley
Version
RK MonoLine Z 40
RK MonoLine Z 60
RK MonoLine Z 80
RK MonoLine Z 80
RK MonoLine Z 120
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
124
NOTICE!
Safety factors are not taken into account!
– Take into account the safety factors for the
sizing of the linear unit specific to the applica-
tion.
NOTICE!
Property damage due to load data being
exceeded!
There is a risk of material damage if the shear
forces, torques and speeds of the linear unit as
defined by RK Rose+Krieger GmbH are exceeded.
– Never exceed the permissible shear forces,
torques and speeds listed below.
To determine the total mass that the linear unit can move in
dynamic mode, consider the following:
F = m * a
x max
n F : Maximum feed force [N]
x max
n m: Total mass to be moved [kg]
n a: Acceleration [m/s²]
No-load torque,
max. [Nm]
0.35
0.8
1.0
1.0
1.8
Pulley pitch cir-
cumference [mm]
85
175.99
192
192
239.99
Pulley pitch diam-
eter [mm]
27.08
56.02
61.12
61.12
76.99
27.10.2023