RK Rose+Krieger RK MonoLine R Montageanleitung Seite 107

Assembling the adapter flange
Fig. 31: Assembling the adapter
flange
5.4.3 Assembling the drive shaft
Applicable to
Assembling the adapter washer
Fig. 32: Assembling the adapter
washer
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
27.10.2023
Assembling optional modules > Assembling the drive shaft
10. Slide the adapter flange (Fig. 31/2) onto the pulley boxes/
intermediate plates (Fig. 31/1).
11. Tighten 4 screws each (Fig. 31/3), alternating diagonally:
Size Screw size
40 M4
60, 80, 120 M8
12. Position the protective tube in the adapter flanges and fix
them using the set screws (Fig. 31/4).
ð The synchronisation shaft is assembled.
Version RK MonoLine Z
Size 40/80/120
Personnel:
Protective equipment:
Prerequisite:
n The electric gear unit and/or motor (if available) are secured
against restarting.
1. Place the centring collar of the adapter washer (Fig. 32/2) on
the timing belt shaft (Fig. 32/1).
2. Tighten 4 screws (Fig. 32/3) alternating diagonally:
Size Screw size
40 M4
80, 120 M8
Tightening torque [Nm]
3
25
n Assembly staff
n Protective clothing
n Protective gloves
n Safety shoes
Tightening torque [Nm]
3
40
Assembly
107