RK Rose+Krieger RK MonoLine R Montageanleitung Seite 105

5.4.2.2 Assembling the synchronisation shaft (with protective tube)
Applicable to
Assembling the intermediate plate
Fig. 27: Assembling the intermediate
plate
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
27.10.2023
Assembling optional modules > Assembling the synchronisation shaft
Size Screw size
40 M3
60, 80 M6
120 M8
ð The synchronisation shaft is assembled.
Version RK MonoLine Z, Z
Size 40/60/80/120
Personnel:
Protective equipment:
Prerequisites:
n The electric gear unit and/or motor (if available) are secured
against restarting.
n Linear units to be connected must be fixed in the substrate.
The synchronisation shaft for the RK MonoLine Z
60, Z 80 and Z 80
because it does not have to be equipped with an
intermediate plate.
1. Place the intermediate plate (Fig. 27/1) on the pulley box
(Fig. 27/2) of both linear units.
2. Tighten 4 screws each (Fig. 27/3), alternating diagonally:
Size Screw size
40 M5
120 M8
Tightening torque [Nm]
1.4
10.5
25
n Assembly staff
n Protective clothing
n Protective gloves
Safety shoes
n
does not require the first step
Tightening torque [Nm]
4
25
Assembly
105