RK Rose+Krieger RK MonoLine R Montageanleitung Seite 103

Assembling the motor plate
Fig. 23: Assembling the motor plate
Assembling the motor
Fig. 24: Assembling the motor
Linear unit RK MonoLine R/RK MonoLine Z/RK MonoLine Z corrosion-protected
27.10.2023
Assembling optional modules > Assembling the motor
7. Tighten 4 screws (Fig. 22/3) alternating diagonally:
Size Screw size
40 M5
60, 80, 120 M8
8. Place the motor plate (Fig. 23/2) on the coupling housing
(Fig. 23/1).
9. Tighten 4 screws (Fig. 23/3) alternating diagonally:
Size Screw size
40 M5
60, 80, 120 M6
10. Place the motor (Fig. 24/3) on the motor plate (Fig. 24/2).
Ensure that the clamping hub on the motor
shaft engages correctly in the screw-in hub
on the timing belt shaft.
11. Tighten 4 screws (Fig. 24/1) alternating diagonally:
Size Screw size
40 M5
M6
60, 80 M5
M6
M8
120 M10
M12
Refer to the table for the screw size and
the associated tightening torque which corre-
spond to the motor to be installed.
ð The motor is assembled.
Assembly
Tightening torque [Nm]
5.9
25
Tightening torque [Nm]
4
10
Tightening torque [Nm]
5.9
10
5.9
10
25
49
85
103