PRotos V2.0 3D Drucker Handbuch
In der configuration.h Datei wird dann noch dir Firmware auf die eigenen Bedürfnisse angepasst.
//// The following define selects which electronics board you have. Please choose the one that
matches your setup
// PRotos RAMPS 1.2 = 3// PRotos RAMPS 1.3/1.4 = 33 one Extruder (Power outputs: Extruder, Bed, Fan)
// PRotos X400 RAMPS 1.3/1.4 = 35 one Extruder (Power outputs: Extruder, Bed, Fan)
#define MOTHERBOARD 33
//// The following is your used extruder type
// Hinged/Wade Exruder = 1
// DD-Extruder = 2
// DD-Extruder dual = 3
#define EXTRUDER 3
// LCD and SD support
#define ULTRA_LCD //general lcd support, also 16x2
#define SDSUPPORT // Enable SD Card Support in Hardware Console
© German RepRap GmbH
Seite
Revision
Stand
Kapitel 4. Inbetriebnahme › Inbetriebnahme Mac OS X
241 /
352
23.12.2013 14:03
241 /