two trees TS2 Benutzerhandbuch Seite 24

b) Add position preview code for GCODE exported from LaserGRBL software
2.1 Click "MKS NC Tool" to launch the software.
2.2 Select the file to edit, click "Change" and save the changed file.
NOTE: The function could help increase reading speed of the engraver for outer
contour scanning.
c) Flash firmware for motherboard. (NOTE: Please do not flash the firmware at will.)
3.1 Click "MKS ESP32 Download Tool" to launch the software.
3.2 Select the file needs flashing (in .bin format).
3.3 Type in values for SPI SPEED\FLASE SIZE\COM\BAUD as per image 2 (COM port
number would vary based on your computer).
3.4 Click "Start" to start flashing.
FIGURE 1 FIGURE 2
2. APP connection tutorial
Search and find "MKS Laser" in APP market/online shop or get the software in TF Card.
Launch the "MKS Laser" mobile APP and enter the connection page.
Type in the IP address obtained in previous tutorial, click "Connect" enter the front page.
24