two trees TS2 Benutzerhandbuch Seite 18

NOTE: If you cannot find the correct port in the "Ports", you may need to:
Method 1: Click "Tools" in the menu to install CH340 driver (The function is not available
in some software versions),
Method 2: Copy the "CH340ser.exe" file in the TF Card (USB flash disk) to the computer
and install it.
1) After the laser head has been used for a period of time, it is necessary to clean the
lens of the light outlet under the laser head to ensure normal cutting ability.
2) Wiping the lens must be done after the machine is powered off, otherwise the laser
will hurt people.
3) After wiping the lens, please dry it naturally for about 3-5 minutes and wait for the
lens to dry before powering it on, otherwise the light will cause the lens to break.
4) You can watch the video tutorial by scanning the QR code of the manual.
Reference of materials
For engraving:
Material
Plywood
Acrylic
Leather
Electroplated coating
Powder coating
Anodic alumina
Stainless steel
Density board
Peddle
Plastic board
Cardboard
Choose the correct port
Choose baud rate 115 200
Successful
Speed (mm/min)
6000
6000
6000
1000
6000
6000
3000
6000
6000
6000
6000
18
Lightning sign
Power (%) Times
50
20
20
100
50
20
100
60
100
40
50
1
1
1
1
1
1
1
1
1
1
1