Endress+Hauser ASP Station 2000 Peristaltik Betriebsanleitung Seite 83

ASP station 2000 peristaltic
!
#
Endress+Hauser
A detailed description of the signal assignment (inputs and outputs) is provided in the Section
"Device configuration".
Note!
The terminal connection is in a protected position beneath the cabinet cover in the electronics
compartment. Therefore to connect the power supply, you must remove the rear panel and the
cover of the device before commissioning. To install the rear panel and the cover, proceed in reverse
order to the descriptions in the following two sections.
4.1.5 Mounting the cover
Warning!
Live equipment
Fig. 7: Mounting the cover
1: Loosen the fixing screws.
2: Lift the cabinet cover at the front.
3: Pull the cabinet cover forwards and lift.
4.1.6 Mounting the rear panel
Fig. 8: Mounting the rear panel
1: Loosen the fixing screws.
2: Lift the rear panel up and remove it.
Wiring
83