Tools And Materials - BestWater Jungbrunnen 66-10 Gebrauchsanleitung

Setting up and connecting
EN

Tools and materials

You will require the following tools and
materials to install the water fi ltration
system:
Drill
●
Drill bits: 3 mm, 7 mm and 12 mm
●
Screwdriver (Phillips-tip)
●
Sockets, box wrench
●
File
●
When washing stone (marble, granite,
etc.) please adhere to the pertinent dril-
ling requirements.
JUNGBRUNNEN
Use specialty tools should additional
work be required.T
66-10/11
The quick connects
You must be able to install and remove
the hose into/from the respective quick
connects on the side of the system in or-
der to properly connect and disconnect
the Jungbrunnen 66-10/11 to/from the
water supply. Use the images below for
assistance and orientation during this
process.
Stick the hose into the socket until you
feel resistance.
The quick connect will fasten the hose
so that it cannot be pulled out uninten-
tionally.
64
In order to remove the hose from the
quick connect you have to push the con-
nector ring toward the front face of the
connector, fasten the ring tightly, and
pull it out from the hose. The quick con-
nect can always be reused.
If the plastic hoses are not properly in-
stalled in the quick couplings, water can
leak out of the BestWater system.
Please note that the maximum hose
length of the system with a 1/4" hose is
5 m.
1. Remove
security ring
2. Push back the
coupling ring
3. Remove
hose