BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 93

is not the case, you can use a food-safe
spray with a Tefl on or silicone base.
Remove the packaging of the new fi lter
inserts and put these in the prepared
prefi lter housings.
Replace prefilter Remove foil packaging beforehand!
Sediment prefilter 5µ Active carbon prefilter Sediment prefilter 5µ
JUNGBRUNNEN
The 1 µ - sediment fi lter is put into the
66-10/11
third prefi lter, the activated charcoal
fi lter is put into the second prefi lter and
in the fi rst prefi lter the 5 µ - sediment
fi lter.
The assembly of the prefi lters is done
in the reverse order to the dismantling.
Put the third prefi lter in fi rst, then the
fi rst prefi lter and at the end the second
prefi lter. While tightening the prefi lter
housing, please use no force but tighten
them only hand tight.
Screw in the prefilter hand-tight
Sediment prefilter 1µ Active carbon prefilter
Maintenance of the BestWater system
Next, you must replace the postfi lters.
See the illustrations on the following
page:
You must fi rst remove the 3 circlips, at
the points shown in the diagram.
Steps 1-2.
Then pull the postfi lter modules out of
the holders.
Steps 3-4.
Finally, pull out the brackets and hoses.
Steps 5-8.
Sediment prefilter 5µ
If the pre-fi lter housings should be the
tightened with the prefi lter housing
wrench, it can happen that the pre-fi lter
housings become jammed due to too
much pressure and make any further fi l-
ter change diffi cult or lead to damage to
the pre-fi lter or the prefi lter housings.
EN
93