BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 95

Make sure that the two lugs are inserted
on the inside of the cover into the slot
provided. Only then can the cover enga-
ge.
Close the maintenance cover in the direction of the front
®
JUNGBRUNNEN
66-10/11
Now you can screw the cover together
again. Proceed in the reverse order as
when dismantling. While tightening the
screws, please use no force.
Close maintenance cover with Torx angled screwdriver
®
Now you can connect the system again
with the extraction points, the water
supply and the drain.
Reconnect the power supply and switch
on the system.
Maintenance of the BestWater system
Torx angled screwdriver
Install Plug-in sockets & hoses
Bitte 5 cm Abstand
zur Rückwand halten!
Schlauchverbindungen dürfen nicht knicken!
Abwasser Tank Hahn Leitungswasser
Position the system again at its original
place. Please note the distance to the
back wall, this should not amount to less
than 5 cm. Open the fl ow of water to the
device and ensure that the stopcock on
the reservoir tank (Jungbrunnen 66-11) is
open.
Open the water supply at the corner valve
Absperrhahn öffnen nur bei Jungbrunnen 66-11
Now check the water stopper or the bat-
tery in the water stopper. Use the dia-
gram on p. 73 as an aid.
Do not use rechargeable batteries, but
only only use an LR 6 alkaline battery, as
these will not discharge on its own and
can be used for one year in the Water-
Stopper without any problems.
After each fi lter change, the system must
be put into operation (see chapter Com-
missioning).
EN
öffnen
95