Setting Up And Connecting; First Steps; Tools And Materials - BestWater Jungbrunnen 25-00 ULTIMATE Gebrauchsanleitung

Setting Up and Connecting

EN

First steps

Determine where you will install the wa-
ter filtration system and faucet.
The System should be easily accessible
●
and simple to use.
The plastic hoses should have a simple
●
pathway (risk of buckling).
The water filtration system and der
●
water stopper on the corner valve should
be easily visible and usable upon instal-
lation.
Conduct a trial installation in which all of
the elements are placed in their inten-
ded positions.
Install the unit as described on the fol-
lowing pages. The necessary connec-
tions are, in order:
Drain clamp
●
Water stopper
●
Water line
●
Water filter
●
Connect the assembled connections
with the water filtration system. Begin
using the water filtration system.

Tools and materials

You will require the following tools and
materials to install the water filtration
system:
Drill
●
Drill bits: 7 mm
●
Screwdriver (Phillips-tip)
●
The quick connects
You must be able to install and remove
the hose into/from the respective quick
connects on the side of the system in
order to properly connect and disconnect
44
JUNGBRUNNEN 25-00
the Jungbrunnen 25-00 Ultimate to/from
the water supply.
Use the images below for assistance and
orientation during this process.
Stick the hose into the socket until you
feel resistance (approx. 1.5 cm). Now
push the hose until it clicks (approx. 1
cm).
The quick connect will fasten the hose
so that it cannot be pulled out unintenti-
onally.
In order to remove the hose from the
quick connect you have to push the con-
nector ring toward the front face of the
connector, fasten the ring tightly, and
pull it out from the hose. The quick con-
nect can always be reused.
Water may leak out from the BestWater
system if the plastic hoses are not pro-
perly installed into the quick connects.
Please note that the maximum hose
length of the system with a 1/4" hose is
5 m
1. Sicherungsring
herausziehen
2. Kupplungsring
1. Remove
zurückdrücken
security ring
2. Push back the 3. Rohr
coupling ring
entfernen
1. Remove
security ring
3. Remove
2. Push back the
hose
coupling ring
3. Remove
hose