BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 67

The designer faucet
Find out where you will assemble the
unit before installing the faucet.
In doing so, note the following:
The faucet should be in a location
●
where it is easy to use. Please note
the turning direction of the fi tting you
are using.
Consider the feasibility of assembly
●
and connection beneath the sink.
Use drill bit sizes 3 mm, 7 mm, and 12
mm for the opening in the tabletop or
sink surface. Start with the smallest dia-
JUNGBRUNNEN
meter and lower rotation, and slowly in-
crease these.
66-10/11
Rework the opening with the round fi le
and remove any residue. When the sink
is made out of stone (marble, granite,
etc.) please adhere to the pertinent dril-
ling requirements.
Designer faucet drilling a hole into the counter top
Place the faucet in the drill hole on the
sink surface.
Fitting designer faucet into the counter top
Setting up and connecting
Plug the supplied parts onto the threa-
ded pipe in the correct order (fi gure on
the right) and align the faucet.
Screw the large plastic washer, the
washer and the fastening nut onto the
thread of the extraction tap. Use a ring
wrench to tighten the fastening nut.
Fastening the designer faucet under the sink
Sink
Now screw the plug connector with in-
ternal thread onto the thread of the ex-
traction tap.
Fastening the plug-in connector IT hand tight under the sink
Sink
Please note that the maximum hose
length for this system is 5m for a 1/4"
hose.
No additional fi ttings may be installed
between the device and the faucet (e.g.
depressurisers, check valves, etc.)!
The IT plug-in connector should only be
screwed fi nger-tight onto the thread of
the faucet. Otherwise, this could be de-
stroyed.
EN
Counter top
Counter top
67