BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 86

Operation of the system
EN
and, as with membrane fl ushing, a
fl ushing noise is heard.
If you press the (+) button a second time,
you can you can switch on the pumps in
the switch on the system. The display will
show the following message:
Pumps – on
ESC <-
With the ESC key
me again and return to the operating
mode menu.
JUNGBRUNNEN
Reading out system data
66-10/11
To be able to display the system data the
operating hours display must be called
up with the B key.
OPERATING HOURS:
SELECT DISPLAY
WITH "+" OR
A <-
Press the (+) key to obtain the following
data:
Filter change no later than...
●
Operating hours until fi lter change...
●
Operating hours of the pre-fi lter...
●
Operating hours of pump running
●
time...
Operating hours of permeate
●
production
Resets after fi lter change...
●
When the (+) key is pressed, the indi-
cation appears when the fi lter change
must be carried out. The time can be
read here as a date.
86
– Jungbrunnen 66-10 / 66-11
you leave the program-
"-"
Filter change at the
latest on:
day00015mon00005
A <- year 00015
In this case, the fi lter should be changed
by 15.05.2015 at the latest. If you press
the (+) key again, the number of opera-
ting hours after which the fi lter must be
changed is displayed.
Operating hours to
filter Change:
00000hrs 00015min
A <-
When you press the (+) key again, the
operating hours of the pre-fi lters are
displayed.
Operating hours of
the prefilters:
00000hrs 00000min
A <-
When you press the (+) key again, the
pump running time of the system:
Operating hours of
the pump:
00000hrs 00000min
A <-
If you press the (+) key again, you will see
the total permeate production of the
system.
Permeate production
in total:
00000hrs 00000min
A <-
When you press the (+) key again, the re-
sets after the fi lter change appear. To