BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 91

As soon as the Message „ATTENTION,
maintenance! Please replace all fi lter
units!", appears, maintenance works
are to be carried out.
Attention Maintenance!
replace all filter
units please!
Finish the operating mode "permeate
production" with the ESC-key.
Select the operating mode „Preparation
of maintenance works" in the menu and
acknowledge with the OK-key.
JUNGBRUNNEN
Preparation for
maintenance
66-10/11
ESC <-
Follow the instructions on the display.
Close corner valve
open tap (Withdrawal)
Disconnect the water supply to your
device and open the withdrawal tap. Ac-
knowledge with the OK-key.
Now the pressure is reduced in the inlet
hose. Please, wait until the next message
appears.
Closing the watersupply at the corner vale
Maintenance of the BestWater system
-> OK
Separate the water inlet hose from the
corner valve now and afterwards press
the
Now the device is drained, which takes
up a certain time period. During this
-> OK time, the withdrawal tap must always
remain open. Via this tap, the reservoir is
also emptied with the Jungbrunnen 66-
11
-> OK
If no water comes from the withdrawal
tap the tank has been emptied and you
can fi nish
ESC-key.
In the next step, you disconnect the
appliance from the power supply. For
this purpose, you switch it off and unplug
Turn on the designer faucet
OK-key
to acknowledge.
Seperate hose from
the corner
versions.
Partial draining
of the device
the draining process with the
EMPTY THE TANK
WITHDRAWAL TAP
MUST BE OPEN!
ESC <-
EN
-> OK
91