BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 69

The three fl ow faucet
Before you start installing the tap, fi rst
screw the hoses for cold and hot water
into the three-way tap.
The exact positions are shown in the
diagram on the left. Then you can in-
sert the vitalizing spiral in front of the
drinking water hose and screw the hose
tight.
Once these steps have been completed,
determine the mounting location of the
three-way tap.
JUNGBRUNNEN
In doing so, observe the following:
The faucet should be in a location
●
66-10/11
where it is easy to use. Please note
the turning direction of the fi tting you
are using.
Consider the feasibility of assembly
●
and connection beneath the sink.
Use hole saw sizes 35 mm, for the ope-
ning in the tabletop or sink surface. Start
drilling in lower rotation, and slowly in-
crease these. Rework the opening with
the round fi le and remove any residue.
When the sink is made out of stone
(marble, granite, etc.) please adhere to
the pertinent drilling requirements.
Drilling a hole in the counter top
Place the faucet in the drill hole on the
sink surface an align it.
Setting up and connecting
Insert the three way faucet into the counter top
Plug the rubber seal and the mounting
bracket onto the mounting bolts and
then screw them to the mounting bolts
with the nuts. Use a ring wrench to tigh-
ten the fastening nut.
Anchor the Three way faucet under the sink
Counter top
Sink
Now screw the plug connector with inter-
nal thread onto the thread of the Potable
water hose extraction tap.
Please note that the maximum hose
length for this system is 5m for a 1/4"
hose.
No additional fi ttings may be installed
between the device and the faucet (e.g.
depressurisers, check valves, etc.)!
The IT plug-in connector should only
be screwed fi nger-tight onto the thread
of the faucet. Otherwise, this could be
destroyed.
EN
Sink
69