Spare Parts And Accessories - BestWater Jungbrunnen 66-10 Gebrauchsanleitung

* The fl ow pressure must amount to at least 150 kPa and may not exceed 450 kPa excess
pressure. If it is higher than 450 kPa excess pressure, a pressure reduction valve must be
installed.
** The consumption data can deviate from the stated values depending on water pressure,
water hardness, water inlet temperature, room temperature, fl uctuations in the mains vol-
tage and selected additional functions.
If the shown values and/or tolerances are exceeded or undershot, this can led to damage
of the BestWater system.
A loss of warranty cannot be excluded.
Spare parts for Jungbrunnen 66-10 / 66-11
Designation
Plastic hoses 1/4" per running. m white
JUNGBRUNNEN
Plastic hoses 3/8" per running. m white
Drain assembly set 1/4"
66-10/11
Stopcock AHDL 383801
Plug connector for withdrawal tap UNS thread
Reduction connector RVS 143801 1/4" - x 3/8" hose (straight)
Plug connector SVT 383801 (T-Form)
Screw-in EVG 3415 3/4" AG x 15 mm tube
Reducing adapter RSG 3815
Water stopper
Accessories
Designation
Reservoir pressure vessel approx. 41.5 l
Reservoir pressure vessel approx. 75.5 l
Designer-withdrawal tap (stainless steel) matt
Designer-withdrawal tap (stainless steel) glossy
Three-way withdrawal tap (stainless steel) matt
Three-way withdrawal tap (stainless steel) glossy
Pressure control valve 1/4" with pressure gauge (0.5 - 10 bar)
Connection set Jungbrunnen 66-11
Torx key wrench T15 with inner hole
Technical information
Art.No.
101018
101074
101012
108056
101014
108034
108021
706005
706006
101003
Art.No.
101058
101072
101055
706199
101066
706152
101097
104018
104019
EN
101