BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 73

The reservoir pressure tank
The reservoir pressure tank, with its
connections and the connection adap-
ter, is only included in the Jungbrunnen
66-11 variant and must be connected.
Proper functioning is only guaranteed
if the storage pressure tank is installed
vertically (e.g. under the sink).
The water supply to the storage pressure
tank is open when the stopcock lever is
aligned parallel to the hose.
When installing the storage pressure
JUNGBRUNNEN
tank, proceed as follows:
66-10/11
Installing the stored pressure tank side view
1.
Shut-off valve open
3 .
close
●
●
If you want to operate a washing ma-
chine or dishwasher with the permeate
produced, please use the connection ad-
apter supplied for operating a washing
machine or dishwasher. The installation
of the connection adapter is described
on the next page.
Shut-off valve
Shut-off valve closed
open
Setting up and connecting
Attach the shut-off valve to the
reservoir pressure
Attention the thread of the reservoir
is already wrapped with Tefl on tape!
Insert the plastic hose into the shut-
off valve into the stopcock as far as it
will go (approx. 2.5 cm).
Make sure that the shut-off valve should
be observable and easy to operate when
installed.
2 .
Hose from BestWater system
Storage pressure tank installed
4 .
®
Jungbrunnen 66-11
Modell: Jungbrunnen 66-11
Power: ~230V - 50Hz - 175VA
1,5 l / min bei 6 ºC
66-11 / 110144
Technischer Support:
E-Mail: technik@BestWater.de
Tel.: +49 (0) 33204 / 62 86 28 www.BestWater.de
Bitte 5 cm Abstand
zur Rückwand halten!
Schlauchverbindungen dürfen nicht knicken!
Abwasser Tank Hahn Leitungswasser
EN
tank.
73