BestWater Jungbrunnen 66-10 Gebrauchsanleitung Seite 65

The drain
The drain of the BestWater system can
be applied to all 40 - 50 mm thick plastic
hoses with ease. Figure out where you
will set up the drain clamp before instal-
lation.
Note that the water drain should be vi-
sible once completely installed.
Drain drilling Frontview
(with marks)
JUNGBRUNNEN
66-10/11
Drain clamp installation Sideview
1.
Foam rubber gasket
( 7 mm Ø hole)
Screw
Drain clamp 40 mm Ø
(1/4" Plug-in connector)
3.
Drain hose 1/4" 1.
Plug-in connector 1/4"
Nut
2.
Setting up and connecting
After you have determined where the
drain clamp will be installed, drill a hole
above the air trap with a 7 mm drill bit.
Remove the residue after drilling.
Fasten the clamp to the trap. Turn the
screws equally among the drain installa-
tion kit.
No additional fi ttings (pressure reducers,
check valves, etc.) may be installed on
the hose to the drain clamp.
2.
Drain clamp installed Frontview
(with installed drain hose)
EN
65