Herunterladen Inhalt Inhalt Diese Seite drucken

Accessories; Appropriate Use - BestWater Jungbrunnen 66-10 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für Jungbrunnen 66-10:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

cleaning and maintenance, the BestWa-
ter system is always be disconnected
from the mains.
The BestWater system is to be connec-
ted to the water supply only under use
of an as good as new hose set. Old hose
sets may not be reused.
The installation and the assembly of this
BestWater system in non-stationary lo-
cations (e.g. ships) may be carried out
only by professional operations / specia-
lists if they ensure the requirements for
safe use of this device.
JUNGBRUNNEN
Do not modify the BestWater system
unless the modifi cations are expressly
66-10/11
authorized by BWI BestWater GmbH.

Appropriate use

Do not install your BestWater system in
frost-prone areas. Hoses can freeze, sys-
tem components can tear or burst and
the reliabilities of the electronics as well
as the pumps can decrease through tem-
peratures below freezing.
Close off the water tap in cases of exten-
ded absence (e.g. vacation).fl ooding risk!
Check the drain hose during the
commissioning
of
system
for
whether
drains out quickly enough. Protect
the drain hose against slipping out.
The repulsive force of the water fl owing
out during the fl ushing can press the not
secured hoses and/or wrongly fastened
hoses from the drain clamp!
Never clean the BestWater system with
solvent-based cleaning agents (e.g. ben-
zine).
the
BestWater
the
water
Safety remarks and warnings
Device components may be damaged
and toxic fumes can appear. There is fi re
risk and danger of explosion!

Accessories

Accessories may only be mounted or
installed if they have been express-
ly released by BWI BestWater GmbH.
If other parts are mounted or installed,
the claims from guarantee, warranty and
/ or product liability shall be null and
void.
To connect the BestWater system, an
angle valve with a 3/4" threaded con-
nection is required. If such a valve is mis-
sing, the BestWater system may only be
installed on the drinking water pipe by an
approved plumber.
The BestWater system must not be con-
nected to a drinking water pipe with addi-
tional non-return valves.
BWI BestWater GmbH cannot be held re-
sponsible for be held responsible for da-
mage caused by failure to observe the
safety instructions and warnings.
EN
57

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für BestWater Jungbrunnen 66-10

Diese Anleitung auch für:

Jungbrunnen 66-11

Inhaltsverzeichnis