Operation Of The System; Operating The Jungbrunnen 66-10 - BestWater Jungbrunnen 66-10 Gebrauchsanleitung

Operation of the system

EN
Tapping drinking water
Open the withdrawal tap. For this pur-
pose, the rocker arm is rotated from the
vertical position to the side.
Turn on the designer faucet
If the system is in standby mode for
more than 15 minutes, a message ap-
JUNGBRUNNEN
pears on the display that the following
water withdrawal will start with a rinse
66-10/11
cycle. This way you get drinking water
freshly fi ltered, after approx. 30 seconds
from the tap.
Permeat production
start with rinse
ESC <-
After the rinsing process, the system
Permeat production
Membrane rinse
ESC <-
Permeat production
Permeat rinse
ESC <-
switches to drinking water production.
The display shows the following mes-
sage:
80
– Jungbrunnen 66-10 / 66-11
00080%
00030%
Permeat production
device in operation
ESC <-
To end the drinking water production,
close the withdrawal tap.
Turn off the designer faucet
When water production is fi nished, the
system prepares for standby mode.
Permeat production
rinsing
ESC <-
The BestWater system is now ready for
operation and is in Standby mode
Deactivate system - activate
With the ESC key you can deactivate the
Best- Water system and cancel the se-
lected function when ESC appears on
the ESC appears on the display. Here
the current working status or condition
of the of the system is irrelevant. For va-
rious actions (e.g. rinse, partial empty-
ing), the programme but not the action
is aborted. If one of these actions is to
be cancelled, the appliance must be swit-
ched off at the mains switch!
OPERATING mode:
SELECT DISPLAY
WITH "+" OR
00053%
"-"