Sime UNIQA REVOLUTION 25 Installations-, Gebrauchs- Und Wartungsanleitung Seite 35

Type No. Description
PAR 26 Zone valve / relaunch pump activation delay
PAR 27
Domestic hot water activation delay with
PAR 28
solar power
PAR 29 Anti-legionella function (only hot water tank)
PAR 30 Maximum domestic hot water temperature
PAR 31
PAR 32
PAR 33
PAR 34
PAR 35 Digital / analogue Pressure switch
Maximum time of consecutive runs for
PAR 36
compressor enabled to operate
Rest time for compressor, even where
PAR 37
enabled to operate
PAR 38 Compressor post-operating time (in minutes)
PAR 39 Fan speed in post-ventilation
PAR 40 Modulating pump speed
PAR 41 T modulating pump delivery/return
PAR 42
PAR 43
PAR 44 Minimum time between compressor ignitions
PAR 45 Minimum time between compressor on-off
Return temp. threshold for activating the
PAR 46
compressor (temperature read at heat pump)
PAR 47 System pump forcing (only in winter mode)
PAR 48 Reset parameters (to default)
m
Tampering with the default values may cause serious damage to the appliance.
In the event of a fault/malfunction the message "ALL" will ap-
pear on the display with the alarm number eg. "ALL 04" (Domes-
tic Hot Water Sensor Fault).
Before repairing the fault:
– disconnect the appliance from the mains power by setting the
main switch to "OFF"
OFF
– as a precautionary measure, close the gas isolation valve.
Range
0 .. 99
0 .. 30
-- = disabled
50 .. 80
35 .. 67
0 = water pressure switch
1 = water pressure transducer
2 = water pressure transducer (only pressure
displayed)
-- = No modulation
10 .. 40
0 = Disabled
1 = Enabled
RESET
0 .. 1
Repair the fault and start-up the boiler again.
NOTE: after having repaired the fault, when the alarm number
appears on the display together with the message
(see figure), press the button
to start the appliance up again.
Fig. 42
U.M. Step
Min 1
-- --
°C 1
-- 1
m
% -
°C 1
m
-- --
-- --
y for approximately 3 seconds
Default
1
0
--
60
1
13
15
7
50
--
20
14
13
47
0
0
d
35