Logout; General Parameters - ECOLAB Lubo-DryExx Advanced Betriebsanleitung

7.3.5.1 Message displays
fig. 7.16
7.3.6

Logout

fig. 7.17
7.3.7

General Parameters

fig. 7.18
7.3.7.1 Displays of Parameter Generaly
fig. 7.19
After leaving the picture with button „Back" you see again the "Main Screen".
417101634_Lubo-DryExx_Advanced
The following messages are indicated:
 Fault messages (must be acknowledged)
 Operating signals
 HMI-System messages
 Result of diagnostics
 Scroll in the messages
 Use the scroll-bars
 Leave screen
 Press "Back"
• To reset of actual password
 Press "Logout"
• To go to the "General Parameters"
 Press "Para. Generaly"
The display contains the following announcements:
• Time relief pump
• Time pre tension system
• Time delay of empty signal
• Pulse width of optional oval gear meter (OGM)
• To change variables
 press variable
• To go to "operation mode"
 Press "operation mode"
• To go to "unit counter"
 Press "unit counter"
• To leave "Parameter Generaly"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press " "
- 46 - Rev. 07-01.15