Safety Check - Optimum Optidrill B 24H Betriebsanleitung

aking off, they cannot eliminate these risks completely. Always work carefully and
observe the limits of the machining process.
The drilling machine features the following safety devices:
an emergency stop push button,

a drilling table with T-slots to fix the workpiece or a vice,

a protective cover for the pulleys with positioning switch,

a drill chuck guard, in order to prevent interference with the rotating tool.

1.9

Safety check

Check the drilling machine before each start-up or at least once per shift. Inform the person
responsible immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),

once a week (with the machine in operation) and

after all maintenance and repair work.

Check that prohibition, warning and information signs and the labels on the drilling machine
are legible (clean them, if necessary)

are complete (replace if necessary).

INFORMATION
Organise the checks according to the following table;
General check
Equipment
Guards
Signs,
Markers
Date:
Functional check
Equipment
Emergency stop
push button
Limit switch protective
cover
V-belt
Drill chuck guard
Date:
Safety
Version 2.2.6 - 2020-07-21
Check
Mounted, firmly bolted and not damaged
Installed and legible
Checked by (signature):
Check
After actuating the emergency stop push button the drilling
machine must be switched off.
The drilling machine must not be switched on, if the protective
cover of the V-belts is opened. An opening of the protective
cover during machine operating turns off the machine.
The drilling machine may only switch on, if the drill chuck guard
is closed. The engine must switch off when the drill chuck guard
is opened during operation.
Checked by (signature):
Translation of the original instructions
OK
OK
B24H | B24HV | B28H | B28HV GB
85