Malfunction
Spindle bearing overheating
Rattle the spindle if the
workpiece surface is rough.
Malfunctions
Version 2.2.6 - 2020-07-21
Cause/
possible effects
•
Bearing worn down
•
Bearing pretension is too high
•
Working at high drilling speed over a
longer period of time.
•
Excessive slack in bearing.
•
Spindle moves up and down
•
Adjustment strip loose
•
Clamping chuck is loose
•
Tool is blunt.
•
Workpiece is loose
Translation of the original instructions
Solution
•
Replace
•
Increase bearing clearance for fixed
bearing (taper roller bearing)
•
Reduce drill speed and feed rate
•
Reduce bearing clearance or replace
bearing
•
Readjust bearing clearance (fixed
bearing)?
•
Adjust strip to the correct slack using
the adjusting screw
•
Check, re-tighten
•
Sharpen or renew the tool.
•
Clamp the workpiece firmly.
B24H | B24HV | B28H | B28HV
GB
135