Safety Check - Optimum OPTidrill B 16H Betriebsanleitung

being expelled, but not to remove them completely. Always work carefully and observe
the limit values of your chipping process.
1.10

Safety check

Check the bench drilling machine before each start-up or at least once per shift. Inform the per-
son responsible immediately of any damage, defect or change in operating function.
Check all safety devices

at the beginning of each shift (with the machine stopped),

once a week (with the machine in operation),

after every maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the bench drilling
machine

are legible (clean them, if necessary),

are complete (replace if necessary).
INFORMATION
Use the following table in order to organize the checks.
General check
Equipment
Protective covers
Signs,
Markings
Date:
Functional check
Equipment
EMERGENCY-STOP
Push button
Limit switch protective
cover
V-belt
Drill chuck protection
Date:
Safety
Version 1.1.8 dated 2018-9-13
Check
Mounted, firmly bolted and not damaged
Installed and legible
checked by (signature):
Check
After actuating an EMERGENCY STOP push button the bench
drilling machine must be switched off.
The bench drilling machine must not be switched on, if the pro-
tective cover of the V-belts is opened. An opening of the protec-
tive cover during machine operating turns off the machine.
The bench drilling machine must only be switched on, if the drill
chuck protection is closed. The engine must switch off when the
drill chuck protection is opened during operation.
checked by (signature):
Translation of the original instructions
OPTIMUM
M A S C H I N E N - G E R M A N Y
OK
OK
B16H | B16HV
®
GB
Page 61