1.14.1 Mechanical Maintenance; Accident Report; Electronics; Inspection Deadlines - Optimum OPTidrill DH 40CT Betriebsanleitung

Check that the lifting and load suspension gear

they have sufficient load carrying,

and that it is in perfect condition.
Observe the accident prevention regulations issued by your Employers Liability
Insurance Association or other supervisory authorities applicable to your company.
Fasten the loads carefully. Never walk under suspended loads!

1.14.1 Mechanical maintenance

Remove or install protection safety devices before starting or after completing any mainte-
nance work; this include:

covers,

safety instructions and warning signs,

grounding cables.
If you remove protective or safety devices, re-fit them immediately after the completing the
work. Check if they are working properly!
1.15

Accident report

Inform your supervisors and Optimum Maschinen Germany GmbH immediately in the event of
accidents, possible sources of danger and any actions which almost led to an accident (near
misses).
There are many possible causes for "near misses".
The sooner they are notified, the quicker the causes can be eliminated.
1.16

Electronics

Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
A second person must be present during work on live components to disconnect the power in
the event of an emergency. Disconnect the machine immediately if there is a malfunction in the
power supply!
Comply with the required inspection intervals in accordance with the factory safety directive,
operating equipment inspection DGUV, formerly BVG.
The operating company responsible for the machine must ensure that the electrical systems
and operating equipment are inspected with regards to their proper condition, namely,

by a qualified electrician or under the supervision and direction of a qualified electrician,
prior to initial commissioning and after modifications or repairs, prior to recommissioning

and at set intervals.
The deadlines must be set so that arising, foreseeable defects can be detected in a timely man-
ner.
The relevant electro-technical rules must be followed during the inspection.
The inspection prior to initial commissioning is not required if the operator receives confirma-
tion from the manufacturer or installer that the electrical systems and operating equipment com-
ply with the accident prevention regulations, see conformity declaration.
Permanently installed electrical systems and operating equipment are considered constantly
monitored if they are continually serviced by qualified electricians and inspected by means of
measurements in the scope of operation (e.g. monitoring the insulation resistance).
1.17

Inspection deadlines

Specify the inspection intervals for the machine in accordance with § 3 of the Industrial Safety
Regulation, document these and carry out an operational hazard analysis in accordance with §
6 of the Industrial Safety and Health Act. The inspection intervals in the maintenance section
should be used as reference values.
Safety
Version 1.0.1 - 2021-07-06 Translation of original instruction
DH 40CT EN
65