Assembly; Installation; Fixing - Optimum OPTidrill DH 40CT Betriebsanleitung


Make sure that the attached load does not cause damage to components or paint.
3.4.3

Assembly

WARNING!
Danger of crushing and overturning. The installation of the drilling milling machine must
be performed by at least 2 persons.
3.4.4

Installation

Check that the drilling milling machine foundation is horizontal with a spirit level.
Fix the foot of the drilling milling machine to the substructure with the provided through-holes.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights must be used.
3.4.5

Fixing

In order to provide for the necessary stability of the drilling milling machine connect the machine
with its foot to the substructure. We recommend the use of anchor rods DIN 529 M12 x 200

Fix the foot of the drilling milling machine to the substructure with the provided through-
holes.
INFORMATION
The following illustration shows the machine foot for machines without a coolant system. The
mounting holes on the machine foot for machines with coolant equipment are in a different loca-
tion.
Through-bore
ATTENTION!
Tighten the fixing screws of the drilling milling machine only as much that it is safely
fixed and cannot break away or tilt over.
If the fixing screws are too tight in particular in connection with an uneven substructure it may
result in a broken stand of the machine.
Version 1.0.1 - 2021-07-06
605
Img.3-1: Fixing points
Translation of original instruction
DH 40CT EN
71