Stryker 6100 RUGGED M1 Bedienungsanleitung Seite 49

BASE WEAR STRIP REPLACEMENT (CONTINUED)
Rear Leg Assembly Wear Strips
Required Tools:
Torx T−25
Replacement Procedure:
1. To remove the worn wear strip (item A), use a T−25 Torx wrench to remove the four button head cap
screws (item B) and weld nuts (item C). Save the weld nuts and button head cap screws and discard
the worn wear strip.
2. Using a 1/8" Allen wrench and 3/8" open end wrench, remove the button head cap screws (item C), nuts
(item D) and washers (item E). Discard the worn wear strip. Save the fasteners for reuse.
3. Assemble the cap screws (item C) removed in step 1 through the new wear strip. Thread the weld nuts
(item F) onto the cap screws and tighten them 1−2 turns.
4. Align the three lower holes of the wear strip to the leg assembly and attach it with the cap screws (item
C), nuts (item D) and washers (item E). Tighten the cap screws securely.
5. Align the weld nuts into the T−slot. Apply pressure to the four cap screws and tighten them securely.
6. Repeat for the other side, if necessary.
Preventative Maintenance
1/8" Allen Wrench
1−47
3/8" Open End Wrench