Stryker 6100 RUGGED M1 Bedienungsanleitung Seite 48

BASE WEAR STRIP REPLACEMENT (CONTINUED)
Front Leg Assembly Wear Strips
Required Tools:
Torx T−25
Replacement Procedure:
1. To remove the worn wear strip (item A), use a T−25 Torx wrench to remove the four button head cap
screws (item B) and weld nuts (item C). Save the weld nuts and button head cap screws and discard
the worn wear strip.
2. To remove the worn bumper cover (item D), use a T−25 Torx wrench to remove the five button head cap
screws (item E). Discard the worn bumper cover.
3. Use the five cap screws (item E) removed in step 2 to install the new bumper cover.
4. Assemble the four cap screws (item B) removed in step 1 through the new wear strip. Thread the weld
nuts (item C) removed in step 1 onto the cap screws and tighten them 1−2 turns.
5. Place the wear strip on the leg assembly, aligning the weld nuts into the T−slot. Apply pressure to the
cap screws and tighten them securely.
6. Repeat the procedure for the other side, if necessary.
Preventative Maintenance
1−46