Steer Lock Detent Force Adjustment - Stryker 6100 RUGGED M1 Bedienungsanleitung

STEER LOCK DETENT FORCE ADJUSTMENT

Required Tools:
Flat Blade Screwdriver
Adjustment Procedure:
1. Rotate the steer lock knob (item A) to the locked position (see page 1−21). Ensure both casters are in
the locked position and the steer lock pin is free of debris.
2. Using a 5/32" Allen wrench, verify item B is tight on both sides. If it is not, tighten it securely.
3. Using a 1/4" Allen wrench, remove the set screw (item C) on both sides.
4. Using a flat blade screwdriver, rotate the detent (item D) on both sides counterclockwise until no detent
force is felt.
5. Using a flat blade screwdriver rotate the detent (item D) clockwise, alternating from side to side, 1 turn
at a time, until resistance is felt against the detent plate (item E).
CAUTION
Do not overtighten the detent. Damage to the detent plate could occur.
6. Using a flat blade screwdriver, rotate the detent (item D) counterclockwise 2 1/2−3 turns on each side.
7. Verify the steer lock system is operating properly. Additional adjustment may be required. Rotate the
detent (item D) 1/2 turn clockwise for more detent force or 1/2 turn counterclockwise for less detent force.
8. Using a 1/4" Allen wrench, install the set screw (item C) and tighten against the detent (item D) on both
sides.
Preventative Maintenance
5/32" Allen Wrench
1−44
1/4" Allen Wrench