Reely Mini Hawk Bedienungsanleitung Seite 58

Then check the positions of the two ailerons. To do this,
check the aileron servo lever. It should be approx. at a 90°
angle to the linkage rods (see dashed line in the upper
picture in Figure 6).
The trailing edges of the ailerons must then form a line (6)
with the trailing edges of the wing.
If there are any deviations, loosen the clamping screws
(7) and readjust the ailerons. Then carefully tighten the
clamping screws.
Also simultaneously check the fastening nuts (8) of the
screw nipples. The nipples must be able to turn, but not
wobble.
Following adjustment, unplug the flight battery and then
switch off the remote control transmitter.
Now you can set the wing onto the fuselage.
Make sure that no cables are pinched between
the wing and the fuselage.
Fasten the wing at the front using the M3 x 25 mm screw
and at the back using the two M3 x 20 mm screws. Use the
included hex key (9) to tighten the screws.
58
Figure 8
Figure 9