Information About Flight Controller; Beeps When Switching On; Programming The Joystick Function - Reely Mini Hawk Bedienungsanleitung

12. Information about flight controller

Important!
As already explained when switching on the remote control, the flight controller can be switched to pro-
gramming mode. To prevent inadvertent switching, ensure that the motor function joystick is always in the
lowest position when connecting the flight battery to the flight controller with the remote control switched on.
There is no need to modify programming in any way since the model aircraft comes with an already opti-
mally factory preset flight controller.
a) Beeps when switching on
When the flight battery is connected, the flight controller emits two identical beeps via the motor, indicating that a 2-cell
flight battery has been connected. The two following beeps with different pitches indicate that the flight controller is
working with the default setting and with the brake disabled.
If the motor function joystick is, for example, in the middle position instead of in the lowest position when connecting
the flight battery, the flight controller will interpret this position as a reference point to switch off the motor. Since the
motor control range is limited in this case, unplug the flight battery from the flight controller, push the motor function
joystick to the lowest position and then reconnect the flight battery.
b) Programming the joystick function
The flight controller should recognise the electronic signals for the two corner points or limit values in order to be able
to optimally respond to the control commands for switching off the motor and running the motor with maximum power.
Normally, there is no need to change this setting as it is factory preset.
It may be reasonable to reprogramme the corner points in the flight controller when using a different remote control.
Proceed as follows:
• Switch on the remote control and push the motor function joystick to maximum power.
• Now connect the flight battery to the flight controller.
• After the two beeps, push the motor function joystick to the lowest position (motor off).
• The flight controller emitting another two beeps indicates that it has recognised the lowest position.
• The flight controller then goes into ready status indicated by four regular beeps.
69