Checking The V-Land Function - Reely Mini Hawk Bedienungsanleitung

f) Checking the V-LAND function
The model aircraft has a landing aid allowing its vertical
landing without being damaged. For this purpose, the
tailplane is unlocked and folds upwards by spring force.
The lock is released with the help of a servo that can be
switched using the remote control.
This function is assigned to a switch located on the left
side of the remote control transmitter (see Figure 15 and
Figure 26, no. 9).
When the switch is in the right "OFF" switch position, the
lock is engaged and the tailplane is in a horizontal posi-
tion. This position is required for take-off and normal flight
operation of the model.
When the switch is pushed to the left "ON" position, the
servo lever (1) pushes the lock linkage (2) forward and the
tailplane (3) folds up.
Once unlocked by means of the remote control, the tail-
plane can only be reset by hand.
To lock the tailplane, set the V-LAND switch back to the
"OFF" position. Then the tailplane can be folded onto the
tail of the fuselage.
To lock the tailplane in this position, briefly push the re-
lease lever into the fuselage with your finger (see illustra-
tion in the middle in Figure 3).
Important!
Make sure that the lock linkage is not mechani-
cally limited either in the locked or in the re-
leased position.
If necessary, the linkage can be easily adjusted
by loosening the clamping screws on the screw
nipple (see Figure 26, no. 4) and then re-tight-
ening them.
68
Figure 26