Mounting The Wing - Reely Mini Hawk Bedienungsanleitung

d) Mounting the wing
Before you can mount the wing on the fuselage, you must
first make electrical connections.
To do this, push the connection cable (1) of the aileron
servo through the fuselage opening near the wing saddle
and into the cockpit area.
Then connect the three motor connection wires (2) with
the three wires that come from the flight controller.
There is no special polarity that must be consid-
ered when connecting the motor.
Connect the aileron servo plug (3) to the free receiver out-
put channel 1. Pay attention to the polarity and follow the
cables of the already connected plugs.
Before proceeding to the next assembly step, be sure to
check the direction of rotation of the motor and the align-
ment of the ailerons.
To do this, switch on the transmitter and set the trim to the
middle position for each control channel. The necessary
measures are described in detail in sections 10 and 11.
Push the motor function joystick into the lower position and
connect the charged flight battery (see Figure 7, no. 5).
The flight controller emits four beeps via the motor.
Slowly pushing the motor function joystick upwards starts
the motor. Then push the joystick back to the lowest posi-
tion at once and pay attention to the direction of rotation
of the motor.
If the motor turns clockwise when viewed from the rear, it
is connected correctly.
If the motor turns counter-clockwise, reconnect any two
motor plugs to the flight controller by swapping them.
Then check whether the direction of rotation has changed
and whether the motor is now turning clockwise.
Figure 6
Figure 7
57